Approx. of 13g heavy weight than kit normal carbon graphite chassis. Suitable for the car to make more lower gravity center like carpet or high-grip surface. Optimized chassis shape design will provide perfect chassis flex.
Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5. With this smart spacer, no need to taking off suspension holder for speedy operation.
This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 7mm ones. The ball surface is smoother than that of the conventional one (T050), yet sold at a competitive price.
The T142 drive belt is wider than T105 drive belt amking it the perfect choice for high power motors. Due to the low friction characteristics of the product, T142 drive belt has a shorter life than the drive belt included in the kit. If you use T142 drive belt with a modified motor, conduct maintenance regularly and replace the belt as necessary.
Reviewed steering angle, front D.J.CVD drive shaft. With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle. Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero. Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced. Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip. For high grip surface and expecting quick response, graphite material is recommended to use.
Including 40mm size high speed cooling fan is mounted at back side of motor. Fan is fixed with two screws on the red anodized aluminum fan mount. Since this fan mount is fixed on chassis by one screw so as hardly can not effect chassis flex. Mount is usable for 30mm and 40mm size fan. ※ Not combination usage with T095 Rear balance weight (Left side). ※ Limited-production item.
Reviewed steering angle, front D.J.CVD drive shaft. With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle. Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
Motor mount and center shaft mount are assembled separately. Enable the chassis flex of motor mount area softer. Changing screw position, characteristics of flexibility can be adjusted. Additionally, characteristics of flexibility can be adjusted by changing screw position.